allowable temperature
英 [əˈlaʊəbl ˈtemprətʃə(r)]
美 [əˈlaʊəbl ˈtemprətʃər]
网络 允许温度; 使用环境温度
双语例句
- The condensation point is not the only basis for determining the allowable oil temperature at the inlet of heating station.
确定热油管道允许最低进站油温不宜仅用凝点作为选择依据。 - The allowable oil temperature of pipeline with large diameter can be lower than that of pipeline with small diameter, while transporting the same oil in the same area.
同一地区输送同一种原油，管径大的管道与管径小的管道比，允许最低进站油温应偏低； - When the ratio of the initial rail deformation offset and its wavelength is neglected in influencing the rail elastic distortion wavelength, the calculated allowable temperature variation is not different from that when the ratio is considered.
忽略轨道原始弯曲矢长比对变形波长的影响，计算的允许温差，其结果与变形波长随轨道原始弯曲矢长比变化时的允许温差相差甚微。 - The Study of Minimum Allowable Temperature for Carbon-Manganese Steel Pressure Vessel
碳锰钢压力容器最低使用温度研究 - A great number of both foreign and domestic test data shows: ( 1) The increase of the conductor allowable temperature up to 80 ℃ has no effect on the strength of the wire;
国内外大量试验数据表明：（1）导线允许温度提高到80℃对线材强度无影响； - Therefore it is feasible to increase the conductor allowable temperature of the aluminum steel-reinforced wire ( LGJ or ACSR) to 80 ℃.
因此提高钢芯铝绞线（LGJ或ACSR）导线允许温度到80℃是可行的。 - For equipment insulation, the temperature between the two layers of the insulation is the maximum allowable operation temperature for the outer layer material, and is subject to the temperature change in both inner and outer layers.
对于设备保温而言，两层保温材料夹缝处的温度即为外层保温材料的最大可能使用温度，而该温度会同时受到内、外层保温材料厚度变化的影响。 - Feasibility Study on Increasing Conductor Allowable Temperature and Engineering Practice
提高导线允许温度的可行性研究和工程实施 - The Determination on the Minimum Allowable Inlet Temperature of Waxy Crude Oil Pipeline
含蜡原油管道最低允许进站温度的确定 - The Highest Allowable Film Temperature of YD Series Heat Transfer Oils
YD系列导热油的最高允许膜温 - According to the yield limit of material, the maximum allowable temperature difference in the casing wall due to the step change in temperature and service life of parts with fracture are also derived.
根据汽缸材料的屈服限，推导出发生介质温度突变时，最大的汽缸壁允许温差以及有裂纹部件的使用寿命。 - This paper presents the means to raise propelling motor's power output of a certain torpedo from the view of the reliable direction change, turn speed increase, shaft's mechanical strength, allowable temperature rise and cooling medium on the basis of its structural parameters.
本文根据某型鱼雷推进电机的结构性能参数，从可靠换向、提高转速、轴的机械强度、容许温升、冷却介质等方面阐述了进一步提高鱼雷推进电机输出功率的途径。 - In case that the design code is modified, in which the allowable heating temperature of the conductor is determined to 80 ℃, the test on conductor HT creepage and service life should be implemented and trial operation is also needed in combination of the practical lines.
若修改设计规程，将导线发热允许温度确定为80℃，为安全起见，仍需进行导线高温蠕变及使用寿命的试验研究，并结合实际线路进行试运行。 - Test and Study on Increasing Allowable Temperature for Conductor Heating
提高导线发热允许温度的试验研究 - The determination of minimum allowable inlet temperature should be based on the allowable shutdown time, rheology and yield behavior of crude oil, temperature condition, start-up pressure and flow rate to do a quantitative calculation and combine with the results of site test.
综合分析结果表明，含蜡原油管道最低允许进站温度，应该根据允许停输时间、原油流变和屈服特性、温度条件、启动压力和排量等条件定量计算，并与现场试验相结合来确定。 - To avoid the extinction of reaction or the deactivation of Pt catalyst, the allowable working temperature is 900 ￣ 1100 ℃.
甲烷催化燃烧的允许工作温度为900～1100℃，过低的温度导至熄火，过高则会使铂催化剂失活。 - Based on stress classifying and assessing, the maximum allowable temperature difference between inner and outer surface of thick wall cylindrical shell, which is in stable temperature field and suffers inner pressure and radical temperature difference, is studied.
通过应力分类和评定，研究了稳定温度场中承受内压与径向温度梯度的厚壁圆筒体的最大允许内外壁温差。 - With the density increasing of urban networks, transmission line corridor is decreasing rapidly, increasing conductor allowable temperature could tap the transmission capacity potential of many existing lines sufficiently and reduce the number of new lines or reduce the cost of new lines.
随着电网密度逐渐增大，新建线路走廊日益紧张，提高导线允许温度，可充分发掘大量现有线路的输送能力，节约新建线路数量或降低新建线路的投资造价。 - Feasibility study of 110 kV urban network on increasing conductor allowable temperature in alpine-cold region
高寒地区110kV城网中提高导线允许温度的可行性研究 - The allowable oil temperature in summer can be lower than that in winter.
同一条管道，夏季的允许最低进站油温应比冬季的油温低。 - The effects of power dissipation and construction parameters of the rectifiers on the trasient maximum allowable junction temperature of the rectifiers at surge current are calculated on an electronic computer and analyzed.
应用电子计算机计算分析了元件功率损耗及结构参数对过载瞬时最高结温的影响。 - The basis for lowering treatment temperature and prolonging thermal insulation time, as well as the allowable stress determination of material at high temperature, the strength check of equipment, the rational selection of lowering temperature and the segmented heat treatment are discussed.
具体介绍了降低热处理温度、延长保温时间的依据以及高温下材料许用应力的确定、设备的强度校核、合理选用降低温度数值的方法，对分区分段热处理的方法进行了说明。 - Raising the allowable temperature of the steel-core aluminum conductor from 70 ℃, the temperature stipulated by current regulation, to 80 ℃ can improve 23%-27% of the current-carrying capacity of the conductor.
将钢芯铝绞线允许温度由现行规范规定的70℃提高到80℃，可提高线路输送容量23%~27%。 - It recommend 60 as the safe allowable temperature limits for high-speed railway CWR track.
建议高速铁路无缝线路稳定性安全温升标准为60℃。 - The mass concrete structure could produce large tensile stress due to temperature change. The tensile stress can be controlled in the allowable range by controlling the temperature of mass concrete.
大体积混凝土结构由于温度的变化会产生很大的拉应力，要把这种由温度变化而产生的拉应力控制在允许范围内，就需要对混凝土的温度进行控制。 - According to the maximum entropy method, a program applied to compute reliability of CWR dynamic stability is worked out and put into practice to analyze reliability of CWR dynamic stability, getting the safety allowable temperature under design reliability index.
根据反应极值最大熵拟合法编制了无缝线路动力稳定性可靠度计算程序，分析了高速铁路无缝线路动力稳定性的可靠度，得到满足目标可靠指标的允许温升。 - Improving the conductor allowable temperature is one of the main ways to improve the Transmission Line Capacity.
提高导线允许温度，是提高输电线路输送容量的主要途径之一。 - As for the concrete poured in high-temperature season, the temperature rise is relative high, which may exceed the allowable maximum temperature, thus leading to the sharp temperature drop in the water impoundment and flood control period, which may result in the thermal cracks.
对于高温季节浇筑的混凝土，温升较高，有可能超过设计允许最高温度，蓄水或度汛时温降较大，有可能产生温度裂缝。